使用说明书 Operation Instruction
8.润滑 Lubricating
4
将油注入油盘A位置。
在操作过程中,需经常检查油位高度,如油位低于B位
置时须加油至A位置。
注意:操作机器时,可以通过油窗①检查油润滑情况。
顺 时 针 （+ 转 动 油 量 调 整 螺 丝 ①, 油量 会 增 加,相
反逆时针（-）转动油量调整螺
丝①时,出油量会减少。
注:调 整 该 螺 钉 后,机 器 应 至 少 运 转30秒 钟,然 后 检 旋
梭出油量。
） 出
9.旋梭润滑的调整 Rotary hook lubrication adjustment
Fill oil pan with new special oil up to A .
In the operating process, need to check the level of the oil
level.After filiing the oil pan,the oil surface should lie A lines.
Note:Operating machine,Can through the oil window ① check
the oil lubrication condition.
,
A
B
①
When you turn clockwise the lubrication adjustment
screw① inserted in the front bushing of the lower shaft,the
amount of oil will increase while turning to counterclockwise
(-) will decrease the amount.
Note: Adjust the screws, the machine should be running at least
30 seconds, then check whether the oil into the hook.
(+)
旋梭
hook
减少
lower
增加
Increase
①
加油结束之前，不能接触电源开关，否则误踩踏板启动，可能会受伤事故
加润滑油时，请使用保护身体的眼镜。手套防止与眼或皮肤接触，同时应放在小孩
碰不到的地方。
首次使用机械时，或长时间不使用时，必须加油。
Plug in only after oil supply is finished.If the operator mistakenly steps on the pedal with the
plug in, the machine will start automatically and can cause severe injuries.
When handling lubricants, wear protective glasses or gloves to avoid contact with your eyes
or skin. Inflammation may be caused otherwise. Never drink lubricants since they can cause
vomiting or diarrhea. Keep out of the reach of children.
Operate the machine only after adding oil when the machine is being used for the first time or
has been left unused for a long time.
在以下机器的调整时，请关闭电源开关。误踩踏板机械启动时，可能会发生身体损伤
事故。
使用离合式马达时，关闭电源后，由于惯性，马达会暂时旋转。马达完全停止后，进
行操作。
Always turn off the power when mounting a needle.If the operator mistakenly steps on
the pedal while the power is on, the machine will start automatically and can result in
physical injuries.
When using clutch motor, be aware that the motor will continue to rotate for a while
even after the power is switched off due to inerlia. Starl to work on the sewing
machine only after the motor has come to a complete stop.
To Next Page
Loading...
