Need help?Do you have a question about the Genelec 1029A and is the answer not in the manual?
General| Weight | 5.6 kg |
|---|---|
| Type | Active Studio Monitor |
| Configuration | 2-way |
| Crossover Frequency | 3 kHz |
| Input Connectors | XLR |
| Driver Size | 5 inches |
Describes the 1029A as a bi-amplified two-way active monitoring speaker with high output and broad bandwidth.
Explains how amplifiers are built into the enclosure, simplifying setup and ensuring calibration as a single unit.
Details the 130mm bass driver and 19mm metal dome treble driver, highlighting DCW technology.
Describes the active crossover with parallel bandpass filters and adjustable tone controls.
Details the bass and treble amplifiers, each producing 40W, and mentions driver overload protection.
Covers unpacking, connecting mains and signal, and initial switch settings.
Explains setting tone controls (treble tilt, bass tilt, bass roll-off) to match the acoustic environment.
Advises positioning speakers slightly behind the console using stands to minimize console reflections.
Stresses correct positioning relative to walls for accurate stereo imaging and frequency response.
Details the 3/8" UNC threaded hole for mic stands and Omnimount bracket provision.
Describes using three wall hanging points for vertical or horizontal mounting.
Mentions the inclusion of friction pads for placing the 1029A on flat surfaces.
Lists warnings regarding unearthed cables, water exposure, and high sound pressure levels.
States that the unit contains no user-serviceable parts and requires qualified personnel for repair.
Provides details on cut-off frequencies, frequency response, and acoustic output levels.
Lists input types, subsonic/ultrasonic filter slopes, and crossover frequency.
Details amplifier output power, distortion, signal-to-noise ratio, and mains voltage requirements.
To Next Page
