Need help?Do you have a question about the Genelec 8040A and is the answer not in the manual?
General| Product color | White |
|---|---|
| Recommended usage | Other |
| Suitable for outdoor use | - |
| Tweeter | Yes |
| Number of drivers | 2 |
| Speaker placement | Tabletop/bookshelf |
| Audio output channels | 1.0 channels |
| Woofer diameter (imperial) | 6.5 \ |
| Tweeter diameter (imperial) | 0.75 \ |
| Impedance | - Ω |
| Sensitivity | 105 dB |
| Frequency range | 45 - 21000 Hz |
| RMS rated power | 180 W |
| Crossover frequency | 3000 Hz |
| Total Harmonic Distortion (THD) | 2 % |
| Connectivity technology | Wired |
| AC input voltage | 100 - 230 V |
| Power source type | AC |
Weight and Dimensions| Depth | 223 mm |
|---|---|
| Width | 237 mm |
| Height | 365 mm |
| Weight | 8600 g |
Details the dimensions and types of bass and high-frequency drivers used in the loudspeakers.
Ensures acoustic axes are aimed towards the listening position for optimal sound staging.
Ensures symmetrical placement for balanced stereo imaging and sound consistency.
Advises on positioning speakers away from reflective surfaces to prevent sound image blurring.
Adjusts low-frequency energy output, offering attenuation levels of -2, -4, or -6 dB.
Attenuates bass frequencies around 160 Hz by 4 dB to compensate for desk placement.
Provides three attenuation levels for bass response below 800 Hz near room boundaries.
Specifications for bass and treble drivers, including size and shielding.
Provides the weight specifications for both the 8040A and 8050A models.
Details the height, width, and depth measurements for the loudspeakers.
Specifies the input connector type as XLR female.
States the input impedance of the loudspeakers.
Defines the input level required for maximum short term output.
Specifies the crossover frequency between bass and treble drivers.
Details the operating range and steps for the treble tilt control.
Specifies the operating range for the desktop low frequency control.
Details the operating range and steps for the bass roll-off control.
Details the operating range and steps for the bass tilt control.
Specifies the short term output power for the bass amplifier.
Specifies the short term output power for the treble amplifier.
Notes that long term output is limited by driver protection circuitry.
Details the THD, SMPTE-IM, CCIF-IM, and DIM 100 distortion levels.
Specifies the signal-to-noise ratio for bass and treble amplifiers.
Lists the available mains voltage options for the loudspeakers.
Indicates the operating voltage range for the loudspeakers.
Specifies power consumption in idle and at full output.
To Next Page
