• The Genelec 8200 and 7200 loudspeaker systems
have utilized DSP to allow for all standard AES/EBU
formats of digital audio.
• The 8200/7200 Series will accept sampling rates
ranging from 32kHz to 192kHz.
• The 8200 Series will also accept traditional analog
signals and perform with all the features and benefi ts
of Genelec 8000 Series products.
• AutoCal is an automated loudspeaker system
alignment algorithm within GLM™ and GLM.SE™. A
factory-calibrated Genelec measurement microphone
is included.
• Correctly sets levels, distance compensating
delays, phase (for subwoofers) and room response
equalization.
• SinglePoint and MultiPoint microphone locations for
one, two, or three-person mixing environments.
• Interactive Response Editor provides visual readout
of measured and corrected response curves as well
as full manual editing of acoustic settings.
• Genelec Loudspeaker Manager™ (GLM™) is a
computer software that provides necessary control
of all loudspeakers on the network.
• Up to 25 loudspeakers and 5 subwoofers are defi nable
and controllable via standard CAT5 cabling.
• All functions and settings are stored in GLM System
Setup Files or directly into each loudspeaker.
• Genelec Loudspeaker Manager for Small
Environments (GLM.SE™) is a computer software
that provides complete control of the GLM.SE™
Monitoring System.
• Standard CAT5 cabling connects the host computer to
the SE7261A DSP subwoofer and up to eight 8130A
digital input monitors, connected to the subwoofer
with standard AES/EBU cabling.
• All functions and settings are stored in GLM System
Setup Files or directly into the SE7261A subwoofer.
To Next Page
Loading...
Need help?
General
