3
USING THE 8240A AND 8250A IN STAND-ALONE MODE
The 8240A and 8250A accept both analogue line level input signals and AES/EBU formatted digital input
signals.
When the 8240A and 8250A are not connected to Genelec loudspeaker control network, they operate
in the stand-alone mode. However, settings made with the Genelec Loudspeaker Manager software can
be saved into each loudspeaker and applied even when the network is disconnected by setting
switch 1
“STORED/MANUAL CONTROL” on switch group 2 of each loudspeaker to position “STORED.”
This manual concentrates on using the 8240A and 8250A without the control network. All issues concerning
use with the network are explained in detail in the System Operating Manual provided with the GLM™
Loudspeaker Manager software kit.
Connections
Each loudspeaker is supplied with a mains cable, one 5 m GLM network cable and an operating manual.
Before connecting up, ensure that the mains switch is off.
“MAINS INPUT” connector
Connect the mains supply to this connector.
To Next Page
Loading...
Need help?
General
