Owner’s Manual for Mobile Light Tower 33
Operation
Lifting the Unit
Proceed as follows to prepare the unit for lifting:
1. Verify the equipment being used to lift the unit is in
good condition and has sufficient capacity. For
approximate weights, refer to Specifications.
2. Close and lock all hoods and doors.
3. See Figure 3-22. Stow the mast and lights in the
travel position as shown.
4. Always remain aware of people and objects around
the unit while preparing, maneuvering, and lifting
the unit.
• When lifting the unit, attach any slings, chains, or
hooks directly to the central lift point (A). The
central lift point is located on top of the enclosure,
connected to a lift structure inside the unit.
Figure 3-22. Lifting Points
• Use the forklift pockets (B) with care. Lift directly
from the rear. Avoid approaching the unit at an
angle, as this can permanently damage the forklift
pockets, tires, or cabinet. Verify any obstructions
are clear of the forklift tines before lifting.
Tying Down the Unit
When securing the unit for transportation, verify the
equipment being used to fasten the unit is in good
condition and has sufficient strength to hold the unit in
place during transport.
See Figure 3-23. Use the tie-down points (C) as shown.
Figure 3-23. Tie-Down Points
To Next Page
Loading...
