Generac Power Systems 0065781 - Page 44

EXPLODED VIEW: EV CONBOX 390 MODULE
DRAWING #: 0J1339 GROUP A
APPLICABLE TO:
ITEM PART# QTY. DESCRIPTION
REVISION: K-1343-C Page 3 of 4
DATE: 12/2/14
SINGLE MODULE
(1)1 0H95790ST0R 1 MD1 / MD2 CB MODULE 390 ALT
(1)(4) 0H9579DST0R 1 MD1, MAIN MODULE 390 ALT G5.4L
(1)2 0J17560ST0R 1 WIRE TUNNEL, MD1-2 390 ALT
3 0A4456 2 WASHER LOCK SPECIAL 3/8
4 061383 1 LUG SLDLSS 3/0-#4 X 13/32 CU
5 0E1534A 2 PLUG PLASTIC 1.50"
6 056326 2 TRIM VINYL BLACK 1/8GP (7.1”LG)
7 045772 2 NUT HEX M10-1.5 G8 YEL CHR
8 067210B 1 DECAL GROUND
10 0A9457A 1 DECAL NEUTRAL
11 0C2454 4 SCREW HWHT M6-1 X 16 N WA Z/JS
12 024526 4 SCREW HHTT 5/16-18 X 3/4 CZ
13 022129 4 WASHER LOCK M8-5/16
14 022145 4 WASHER FLAT 5/16-M8 ZINC
15 0441140781 1 WIRE ASM, GND 2/0 WIRE 3/8 LUG
16 022131 4 WASHER FLAT 3/8-M10 ZINC
17 049541 2 SCREW HHC M10-1.5 X 35 C8.8
(3)(2)18 0J0455 REF BLOCK, TERM 14 POS X 8 X 1600V
(3)(2)19 0J9078 REF DECAL TB4 HV CUSTOMER CONN
(3)(2)21 0J5462 REF SCREW THTT M4-0.7 X 16 ZP
22 023827 REF BLOCK TERM JUMPER FOR S142/542
NOTES (UNLESS OTHERWISE SPECIFIED):
(1) SHEET METAL PARTS LISTED IN THE BOM TABLE ARE REPRESENTING GENERIC PARTS (NO COLOR)
• MANUFACTURING: FOR CORRECT MATERIAL AND COLOR REFER TO AS400 BOM.
• CUSTOMER: WHEN ORDERING REPLACEMENT PARTS ENTER BASE NUMBER (FIRST 6 DIGITS ONLY) IN THE SYSTEM FOR
CORRECT MATERIAL AND COLOR (FOR REFERENCE SEE GUIDELINE 0H7169).
(2) WILL BE INSTALLED ON PRIMARY CB MODULES ONLY. NOT REQUIRED WITH LOAD CENTER.
(3) NOT REQUIRED IF EQUIPPED WITH 0J1594, KIT BATTERY CHARGER POWER CORD.
(4) G5.4L Y01 UNITS ONLY.
DUAL MODULE
(1)1 0H95790ST0R 2 MD1 / MD2 CB MODULE 390 ALT
(1)(4) 0H9579DST0R 2 MD1, MAIN MODULE 390 ALT G5.4L
(1)2 0J17560ST0R 2 WIRE TUNNEL, MD1-2 390 ALT
3 0A4456 4 WASHER LOCK SPECIAL 3/8
4 061383 2 LUG SLDLSS 3/0-#4 X 13/32 CU
5 0E1534A 4 PLUG PLASTIC 1.50"
6 056326 4 TRIM VINYL BLACK 1/8GP (7.1”LG)
7 045772 4 NUT HEX M10-1.5 G8 YEL CHR
8 067210A 2 DECAL GROUND LUG
9 0H8006 2 DECAL CAUTION ELEC SHOCK SM
10 0A9457 2 DECAL NEUTRAL
11 0C2454 8 SCREW HWHT M6-1 X 16 N WA Z/JS
12 024526 8 SCREW HHTT 5/16-18 X 3/4 CZ
13 022129 8 WASHER LOCK M8-5/16
14 022145 8 WASHER FLAT 5/16-M8 ZINC
15 0441140781 2 WIRE ASM, GND 2/0 WIRE 3/8 LUG
16 022131 8 WASHER FLAT 3/8-M10 ZINC
17 049541 4 SCREW HHC M10-1.5 X 35 C8.8
(3)(2)18 0J0455 REF BLOCK, TERM 14 POS X 8 X 1600V
(3)(2)19 0J9078 REF DECAL, TB4 HV CUSTOMER CONN
(3)(2)21 0J5462 REF SCREW THTT M4-0.7 X 16 ZP
22 023827 REF BLOCK TERM JUMPER FOR S142/542
NOTES (UNLESS OTHERWISE SPECIFIED):
(1) SHEET METAL PARTS LISTED IN THE BOM TABLE ARE REPRESENTING GENERIC PARTS (NO COLOR)
• MANUFACTURING: FOR CORRECT MATERIAL AND COLOR REFER TO AS400 BOM.
• CUSTOMER: WHEN ORDERING REPLACEMENT PARTS ENTER BASE NUMBER (FIRST 6 DIGITS ONLY) IN THE SYSTEM FOR
CORRECT MATERIAL AND COLOR (FOR REFERENCE SEE GUIDELINE 0H7169).
(2) WILL BE INSTALLED ON PRIMARY CB MODULES ONLY. NOT REQUIRED WITH LOAD CENTER.
(3) NOT REQUIRED IF EQUIPPED WITH 0J1594, KIT BATTERY CHARGER POWER CORD.
(4) G5.4L Y01 UNITS ONLY.