Generac Power Systems 941-2 - Engine DC Control System

Section 6.1
ENGINE DC CONTROL SYSTEM
GENERAL
The engine DC control system consists of all those
electrical components required for cranking, starting
and running the engine. These components include
the following:
1. Engine cranking system components
a.A 12 VDC battery.
b.A Start-Run-Stop Switch (SW1).
c. A Starter Contactor (Starter Relay)-(SC).
d.A Starter Motor (SM).
2. Fuel system components..
a.A Fuel Primer Switch (SW2).
b.Fuel Pump (FP).
3. Engine Ignition System Components.
a.Ignition Module (IM).
b.Ignition Sensor (IS).
c. Ignition Coil (IC).
d.Spark Plug (SP).
4. Engine Protective Devices a. Low Oil Pressure Switch (LOP).
b. High Oil Temperature Switch (HTO).
5. An optional Remote Panel.
(continued)
Page 6.1-1
Figure 1. Schematic- Engine DC Control System