Generac Power Systems GP Series User Manual

Owner’s Manual for Portable Generator 9
Remove Contents from Carton
1. Open carton completely by cutting each
corner from top to bottom.
2. Remove and verify carton contents prior to
assembly. Carton contents should contain
the following:
Accessories
3. Call Generac Customer Service 1-888-
GENERAC (1-888-436-3722) with the unit
model and serial number for any missing
carton contents.
4. Record model, serial number, and date of
purchase on front cover of this manual.
Assembly
Call Generac Customer Service at 1-888-
GENERAC (1-888-436-3722) for any assem-
bly issues or concerns. Please have model
and serial number available.
The following tools are required to install the
accessory kit.
• Needle Nose Pliers
• Ratchet Wrench
• 8mm Socket
• 12mm Socket
• 13mm Socket
• 10mm Wrench
• 13mm Wrench
• 8mm Wrench (2) (electric start only)
• 19mm Wrench
NOTE: The wheels are not intended for over-
the-road use.
See Figure 2-9.
Install wheels as follows:
1. Slide axle pin (E) through the wheel (B),
wheel bracket on frame, and 1/2” flat
washer (G).
2. Insert cotter pin (F) through axle pin (E).
Bend tabs (of cotter pins) outward to lock
into place.
Install frame foot and rubber bumpers as fol-
lows:
1. Slide hex head bolts (L) through rubber
bumper (D), then through frame foot (C) (if
not pre-assembled).
2. Slide hex head bolts (K) through holes in
frame rail.
3. Slide frame foot (C) onto hex head bolts
(K). Install locking flange nuts (J).
Figure 2-9. Wheel & Foot Assembly
See Figure 2-10.
Install handle as follows:
1. Slide long bolts (K) through handle bracket
and handle (A). Install hex nuts (J).
Item Qty.
Main Unit 1
Owner’s Manual 1
Liter Oil SAE 30 1
Handle Assembly (A) 1
Never-flat Wheel (B) 2
Frame Foot (C) 2
Product Registration Card 3
Service Warranty 1
Emissions Warranty 1
25’ Power Cord (if equipped) 1
Battery Charger (electric start mod-
els)
1
1st Stage LP Regulator and Hose 1
Hardware Bag Qty.
Rubber Feet (D) 2
1/2” Axle Pin (E) 2
Cotter Pin (F) 2
1/2” Flat Washer (G) 2
Hex Flanged M6 Nut (H) 2
Hex Flanged M8 Nut (J) 6
M8 Bolt (Long) (K) 6
M6 Bolt (Long) (L) 2
M8 Nylon Flat Washer (M) 4
(000100a)
Consult Manual. Read and understand manual
completely before using product. Failure to
completely understand manual and product
could result in death or serious injury.
WARNING
E
F
L
H
J
K
C
G
006620
B

Generac Power Systems GP Series Specifications

General

Brand	Generac Power Systems
Model	GP Series
Category	Portable Generator
Language	English