Generac Power Systems GTV99O

SECTION 9:
ENGINE DISASSEMBLY
Note: Remove
any carbon or idge at the top of the .ylin-
der
bores
to
prevent
breaking ings when rcnoving
piston
and aonneding rod assemblies.
4- Remove No. 2
connecting rod c:p and
push
conn€cting
rod
and
piston
assembly out of cylinder
(Figure
9-4).
a
Reasse-ble
cao ro
rod
lo
prevenl
'nrercharg:n9
5. Repeat{or renraining
cyllnder.
6. Remove
crankshafl
(Figure
9-5).
ligwe
9-5. Renove Oankshalt
7. Remove
oil
pump
frcm crankcase
cover
Note: clean
all suiaces of
gasket
mateial.
Remove
oil
seals and
thotoughly dean components in
solvent. Orga-
nize components,
keeping
pat's
which
are assemblies
together
Figute
9-3, Renove cj,l]shalt
Fiqurc
9-4. Renove Pinons and
Connecring Rods
Figure 9-5. Renove Oil Pump
92