Generac Power Systems OneWASH User Manual

Set-up
IMPORTANT: DO NOT siphon standing water for the
water supply. Use ONLY cold water (less than 100°F).
Water supply must be adequate to handle greater than
3.8 gallons per minute and no less than 30 psi.
NOTE:
Using a One Way Valve (vacuum breaker or check
valve) at pump inlet can cause pump or inlet connec-
tor damage.
• There MUST be at least ten feet of unrestricted garden
hose between the power washer inlet and any device,
such as a vacuum breaker or check valve.
• Damage to equipment resulting from failure to follow
this instruction will void warranty.
• Always wear safety goggles when using this equip-
ment or in vicinity of equipment in use.
• Before starting the power washer, be sure you are
wearing adequate safety goggles.
• NEVER substitute safety glasses for safety goggles.
4. Connect lance to spray gun (Figure 4-13). Tighten by
hand.
,
Figure 4-13. Attach Lance
Attach end of high pressure hose to base of spray
gun (Figure 4-14). Tighten by hand.
Figure 4-11. Inspect Inlet Screen
3. Connect the garden hose (not to exceed 50 feet in
length) to the water inlet (Figure 4-12). Tighten by
hand.
Figure 4-14. Connect Hose to Spray Gun
Figure 4-12. Connect Garden Hose
_4_ Risk of eye injury. Spray can splash back or
. propel objects.
The high pressure stream of water that this
equipment produces can cut through skin and
its underlying tissues, leading to serious
injury and possible amputation.
• NEVER connect high pressure hose to lance.
• Keep high pressure hose connected to pump and
spray gun while system is pressurized.
• Always be certain spray gun, nozzles and accessories
are correctly attached.
14 OneWASH TM Power Washer

Generac Power Systems OneWASH Specifications

General

Brand	Generac Power Systems
Model	OneWASH
Category	Pressure Washer
Language	English