Generac Power Systems PWRcell X7602 User Manual

4 Owner’s Manual for Generac PWRcell Inverter
General Information
Serial Number Location
Refer to Figure 2-2 to locate unit serial number (A).
Record the information from this tag in Table 1: PWRcell
Inverter Important Information on the inside front cover
of this manual.
Unit Dimensions
Figure 2-1. Unit Dimension
Component Locations
Figure 2-2. Component Locations
About PWRcell Inverters
The PWRcell inverter connects to PV Link™ optimizers
and PWRcell batteries to form the PWRcell system for
grid-interactive solar-plus-storage.
Upon the loss of grid power, PWRcell inverters
disconnect from the grid and provide AC power to
support protected loads when configured to do so.
All PWRcell products use the REbus™ 380 VDC
nanogrid to connect to each other. The REbus nanogrid
automates the flow of power to enable plug-and-play
setup and operation of PWRcell equipment. For more
information about REbus, visit www.generac.com.
In Figure 2-3 PWRcell inverter (E) is directly connected
to PV Link optimizers (B) and PWRcell battery (C) on DC
(REbus) line (D). To the right of the inverter are AC lines:
120/240 VAC for grid and home loads (G) and protected
loads (H).
.
Figure 2-3. Generac PWRcell System Example
A
24-3/4 in (628 mm)
B
19-3/8 in (491 mm)
C
8-3/8 in (214 mm)
B
A
C
009955
A Control Panel
B Intake Filter
C Exhaust Vent
D Serial Number Tag
009656
A
B
C
D
A Solar Panels D REbus G Loads
B PV Link E PWRcell Inverter H Protected Loads
C PWRcell Battery F Grid
009893
A
C
D
E
F
G
H
B
B
B
D

Generac Power Systems PWRcell X7602 Specifications

General

Brand	Generac Power Systems
Model	PWRcell X7602
Category	Inverter
Language	English