To Next PageTo Next Page
Need help?Do you have a question about the Generac Power Systems RXSW200A3F and is the answer not in the manual?
General| Type | Automatic Transfer Switch |
|---|---|
| Amperage | 200 Amps |
| Voltage | 120/240V |
| Phase | Single Phase |
| Frequency | 60 Hz |
| NEMA Rating | NEMA 3R |
| Dimensions | 16.5 x 12.5 x 7.5 inches |
General welcome and overview of the product's design and intended use.
Guidelines and principles for safe operation and maintenance of the equipment.
Explanation of warning symbols (DANGER, WARNING, CAUTION) used in the manual.
Specific dangers related to electricity, including electrocution and backfeed hazards.
Broad safety warnings covering electrical, environmental, and operational risks.
Overview of the installation process and preparatory steps.
Instructions and considerations for physically mounting the transfer switch enclosure.
Step-by-step guide on how to open the transfer switch enclosure for access.
Procedures for installing circuit breakers into the transfer switch bus.
Steps for routing and connecting electrical conductors to the transfer switch.
Detailed instructions for wiring the utility and generator power inputs.
Guide for connecting the SACM, likely for control functions.
How to use the SACM to control an air conditioner load.
Instructions for wiring the generator start and sensing circuits.
Information on using the normally-closed auxiliary contact for external devices.
Guidance on applying the fault current identification label as per NEC requirements.
Procedures for testing and verifying the transfer switch's functionality post-installation.
Steps for manually operating the transfer switch, including safety precautions.
Instructions for manually positioning the switch to the utility power source.
Instructions for manually positioning the switch to the generator power source.
Steps to manually move the switch back to the utility power connection.
General guidance on performing voltage measurements using a DMM.
Specific procedure for checking voltage from the utility power source.
Specific procedure for checking voltage from the generator power source.
How to test the generator's performance when powering connected loads.
Steps to verify the transfer switch operates correctly in automatic mode.
Final verification steps and user education recommendations after installation.
Safe procedures for shutting down the generator while it is supplying power.
Steps to safely shut down the generator for maintenance tasks.
Procedure for testing the load shed functions of the SACM using the test button.
Reference to another manual for testing the SMM component.
Instructions on how to safely remove and replace fuses using the provided tool.
Technical drawing providing dimensions and layout for the transfer switch installation.
Diagram illustrating wiring connections for a Liquid-Cooled Engine Generator.
Diagram illustrating wiring connections for a Liquid-Cooled Engine Generator.
Diagram illustrating wiring connections for an Air-Cooled Engine Generator.
Diagram illustrating wiring connections for an Air-Cooled Engine Generator.
