To Next PageTo Next Page
Need help?Do you have a question about the Generac Power Systems RXSW200A3 and is the answer not in the manual?
General| Type | Automatic Transfer Switch |
|---|---|
| Amperage | 200 Amps |
| Phase | Single Phase |
| Enclosure | NEMA 3R |
| Poles | 2 |
| Operation Mode | Automatic |
| Frequency | 60 Hz |
| Voltage | 120/240 Volts |
| Maximum Generator Size | 48kW |
Outlines general safety precautions and manufacturer's recommendations for safe equipment use.
Explains DANGER, WARNING, and CAUTION symbols used in the manual for hazard identification.
Details specific electrical risks associated with the transfer switch and necessary precautions.
Covers general safety concerns, including electrical backfeed, jewelry, and working conditions.
Details the procedures for connecting utility and generator power to the transfer switch.
Guides on performing functional tests after installation to ensure proper operation.
Instructions for manually operating the transfer switch, including safety warnings.
Procedures for checking utility and generator voltage and frequency using a DMM.
Specific steps to check utility voltage at the transfer switch terminals.
Specific steps to check generator voltage and frequency before connecting loads.
Procedure for testing the generator's performance and the transfer switch under load conditions.
Steps to verify the automatic transfer of power between utility and generator sources.
Critical steps for safely shutting down the generator during utility outages or under load.
