Note: If you have already used your HT20 to log data
and it is still in recording mode, plugging the unit in
will cause the following window to appear.
Click Yes to stop recording and import all data recorded to
that point in time. Click No to continue to Setup without
importing recorded data (meaning it will be lost). Click
Cancel to go back and unplug the unit from the USB port.
11
Fig. 2. The three options made available by
plugging the HT20 into a USB port
Device HT20 is connected!
! " # $ % & ' % ( ) * + , - . / 0 1 2 / " 3 4 5 4 ! 4 / % 6 7 3 8 4 5 8 4 ! 9 : " ! ; $ ; % < = 4 4
To Next Page
Loading...