FUNCTIONS
Temperature Control
The room thermostat controls the room temperature according to the set value. The on / off temperature
o
difference of the device is 0.5 C.
Calibration
The room thermostat can be calibrated if the measuring temperature wanted to be changed. The calibration range
o o
is -8 C to + 8 C.
ORDERING
When ordering, specify both the product type and the product code, for example the HT300 wired room
thermostat.
ROOM THERMOSTAT INSTALLATION
Place your room thermostat in a room where you most use it as your living area. For example: living room. Avoid
installing the room thermostat where there is a lot of air circulation such as door entry or window edges. Also, do
not place in places near heat units (central heating system, fireplace, etc.) and places that receive direct sunlight.
We recommend that the room thermostat be placed at an altitude of 50 cm to 150 cm from the floor. You can try a
few places to find the most suitable place.
The wall bracket must be mounted on a flat wall.
Local electrical regulations must be observed.
The parts included in the room thermostat are made of ABS, PC materials.
In systems with room thermostats, if there are thermostatic radiator valves, keep them in the open position.
BATTERY CHANGE
Remove your room thermostat from Wall hanger. Then remove the battery housing from the back side of
thermostat. Install 3V DC (2xAAA) alkaline batteries to battery housing. Please be sure the directions of batteries
Hang your thermostat on the Wall hanger after assemble battery housing back. Change the both batteries
together.
WARNING!
Please throw away dead batteries to trashes special only for batteries.
MAINTENANCE
The device is maintenance-free.
min.50 cm
50 cm-150 cm
generallife.com.tr4 / 9
To Next Page
Loading...