General Titanium Series User Manual

19
USING YOUR LASER (continued)
VERTICAL MEASUREMENT SET UP
Level surface set up
• Select a place as close and practical to the work
site as possible, and ensure that the location is
clear of traffic.
• Place the laser level onto a reasonably level
surface with the control panel facing upwards.
Tripod set up
• Select a place as close and practical to the work
site as possible, and ensure that the location is
clear of traffic.
• Select a place as close and practical to the work
site as possible, and ensure that the location is
clear of traffic.
• Extend the tripod legs to the required height and
then spread the legs wide enough so that the
tripod platform is stable.
• Place the instrument onto the tripod with the
control panel facing upwards and thread the yoke
into the back until firm. Do not over tighten as this
may cause damage to the instrument or tripod.

General Titanium Series Specifications

General

Brand	General
Model	Titanium Series
Category	Laser Level
Language	English