General Titanium Series

25
USING YOUR DETECTOR
POWER SUPPLY
• The detector is powered by four AA alkaline
batteries.
Battery replacement
• Remove the battery door cover.
• Insert the battery according to polarity and replace
the battery door.
MOUNTING THE STAFF CLAMP
• Insert the staff clamp screw into the staff clamp
thread.
• Rotate the nut until the clamp is secured in place.
DETECTOR OPERATION
• Switch the detector on by pressing the power
button. The LCD screen will turn on and the
speaker will emit a small tone to indicate the
instrument is operating.
• The LCD screen will display the battery level,
detection mode, measurement type and speaker
function.
• To change between broad, coarse and fine mode
press the detection mode button.
• Move the detector into the path of the laser beam.
• Hold the detector upright for horizontal beams.
• The direction arrows or level line on the LCD
screen will indicate the position of the laser beam.
The detector will emit a constant beep once the
level position has been located.