How to fix no Bluetooth output on Generalscan Barcode Reader?
If the laser or imager comes out from the scan windows of your Generalscan Barcode Reader, but there is no Bluetooth output, ensure the scanner is programmed to read the type of barcode being scanned. Also, confirm that the output mode is set to Bluetooth. Try moving the scanner closer to or further from the barcode to see if that resolves the issue.
What to do if iOS can't find Generalscan Bluetooth Barcode Reader?
If your iOS device can't find the Generalscan Barcode Reader via Bluetooth, try scanning the Pairing mode barcode. If that doesn't work, remove the paired scanner from your smartphone or tablet's Bluetooth settings and try pairing again.
Why no laser from Generalscan Barcode Reader?
If there is no laser or imager coming out from the scan windows of your Generalscan Barcode Reader, try charging the battery using the Micro-USB port. Also, make sure the power switch is set to the ON position.
What to do if the laser or imager comes out from the Generalscan Barcode Reader but there is no Bluetooth output?
If the laser or imager is active but there's no Bluetooth output from your Generalscan Barcode Reader, ensure the scanner is programmed to read the type of barcode being scanned. Also, confirm that the output mode is set to Bluetooth. Finally, try moving the scanner closer to or further from the barcode.
What to do if my iOS device can't find the Generalscan Bluetooth Barcode Reader?
If your iOS device is unable to find the Generalscan Bluetooth Barcode Reader, try scanning the Pairing mode barcode. If that doesn't work, remove the paired scanner from your smartphone or tablet and try again.
What to do if there is no laser or imager coming out from the scan windows of Generalscan GS WT5000X Barcode Reader?
If no laser or imager is emitted from the scan windows of your Generalscan Barcode Reader, charge the battery using the Micro-USB port. Also, ensure that the power switch is set to the ON position.
What to do if Scanbuddy GS-X series plugged into smartphone can't work and no lighting comes from scan window?
If your Scanbuddy GS-X series isn't working when plugged into your smartphone and there's no light from the scan window, confirm that your device supports the OTG function and can provide at least 300mAh of current to the external scanner. Also, verify that the driver was installed properly.
General| Brand | Generalscan |
|---|---|
| Model | GS WT5000X |
| Category | Barcode Reader |
| Language | English |
To Next Page
