Driving on the slope
When driving on the slope, the motorcycle decreases the speed and seems inadequate power, in that
case, please change the lower gear so that keeping the power. When driving downhill, please change the
lower gear in order to break easily. Please don’t let the engine’s rotate speed too high.
Using the brake system and stopping the motorcycle
Shut down the accelerograph ，turn the steering handle against the driver，use the brake systems
equably, change the lower gear to reduce the speed.
Before the motorcycle stopping, grip the clutch; change the neutral gear, checking the neutral indicator is
ON.
CAUTION：
The driver lack of experience may only use the rear brake, it may let the brake wear quickly and longer
distance before stopping.
WARNING
Only use front brake or rear brake is dangerous，this may bring skid or out of the control。During driving on
the dank or slick rode and the corner use the brake system carefully. Brake suddenly is very dangerous!
Stand your motorcycle on a flate, even surface.
If the motorcycle must stay on the slope, change the gear to the first gear to prevent roll down. Before start
the engine change it to the neutral gear. Let ignition switch on the position of“
”. Take away the key. Turn
the fuel tank switch on the position“”. Lock the handle bar lock.
WARNING
The higher vehicle speed, braking distance will be proportional to the increase.
Please confirm your vehicle or object in front of you with the safe braking distance
With regard new motorcycle at the beginning 1,000km, don’t abuse the engine, don’t let it exceed the
maximum speed of 80%; don’t use it when the choke on the open position, at the same time change the
gear appropriately. If you use the motorcycle using carefully at the beginning time it is benefitable to extend
the service life.
Caution：
At the first 300 km, please clean Oil Filter and adjust valve clearance according the request.
To Next Page
Loading...
Need help?
General
