Generic Trigger X User Manual

The replacement of tail lamp
Caution:
The cathode wire should be reassembled on the frame
Use the screwdriver to driver the screw off, then open the tail lamp cover, replaces a new same standard
bulb on
Attention:
When replacing the bulb, must need the same standard as the original, the higher power bulb will increase
the possibility of battery decrease.
The replacement of fuse
The fuse is located beside the battery, if the fuse does always break, that means that the electric cycle is
inshort circuit or overload. Please contact us soon in order to mend in time.
Alarm:
Do not use other fuse out of standard, that may cause serious
negative effect even will burn lamp, cause fire, or causing losing
engine power, it is very dangerous.
The way of lubricating
Proper lubricate can maintain the excellent work of every part of
motorbike, also can extend the time of using, increase the safety
of driving. After long time driving, raining or water cleaning, we
suggest you to do a lubricate. The details are below:
,Ｙ Motorbike lubricant
,Ｚ Fat lubricant
1. clutch handle shaft ,Ｚ
2. side stand connect bolt and string clasp ,Ｚ
3. shift bar shaft ,Ｚ
4. front break handle shaft ,Ｚ
5. throttle pulling cable ,Ｙ
6. rear break kit shaft ,Ｚ

Generic Trigger X Specifications

General

Brand	Generic
Model	Trigger X
Category	Motorcycle
Language	English

Summary

Safety and Identification

Parts Identification and Dashboard

Location of Motorcycle Parts

Diagram and list identifying key external and internal components of the motorcycle.

Dashboard Indicators Overview

Braking and Seat Access

Brake Operation Guide

How the brake handle and pedal operate the front and rear wheels, including brake light activation.

Pre-Ride Inspection Checklist

Driving Techniques and Safety

Engine Starting Procedures

Step-by-step guide for starting the engine, basic driving, and using the gear system for optimal performance.

Driving Scenarios and Braking

Safe Braking and Stopping

Proper methods for using the brake system to slow down and stop the motorcycle safely, including warnings.

Regular Maintenance Schedule

Fluid Checks and Replacements

Engine Oil Management

Instructions for checking and refilling the engine oil using the specified type and procedure.

Gear Oil Service

Procedure for checking and replacing the gear oil, including draining and refilling steps.

Battery System Maintenance

Battery Handling and Troubleshooting

Information on the maintenance-free battery, troubleshooting, and safe handling procedures.

Brake System Component Checks

Brake Fluid Level Check

Information on the type of brake fluid (DOT3/DOT4) and precautions for handling and checking levels.

Brake Pad and Lever Checks

Guidance on checking the wear limit of brake pads and brake handle/footrest free play.

Brake System and Suspension Adjustment

Brake System Servicing Advice

General advice on brake system repair and daily checks for leaks and wear.

Tire Specifications and Care

Technical Specifications

Electrical System Specifications