33
3. Program TV’s POWER button. While the “EJECT” button is
lit press the GT-3.0 “POWER” button and the red light will slow
flash. While this light is slow flashing, quickly press the POWER
button on the TV remote. If the red light quickly flashes three
times and then continues steady you have succeeded. To mem-
orize and to exit learning mode press “TV” on the GT-3.0 remote.
To verify press the “TV” button on the GT-3.0 remote and then
press the “POWER” button. The TV’s power should come on. If
not you will have to repeat the above process.
Note: If 10 seconds has passed and the learning light has gone
out you will have to start back at #2.
4. To continue to memorize more TV functions on the GT-3.0
remote do the following: Press and hold the “TV” button on the
GT-3.0 remote for longer then 3 seconds and release when the
“EJECT” button in the upper left corner lights red. This puts the
remote in learning mode. While the “EJECT” button is lit press
the GT-3.0 “VOLUME UP” button and the red light will slow flash.
While this light is slow flashing, quickly press the VOLUME UP
button on the TV remote. If the red light quickly flashes three
times and then continues steady you have succeeded. From this
point you can continue to memorize any button using the same
operation. When you are finished memorizing functions Press
the “TV” button on the GT-3.0 remote to exit learning mode.
SAT, Cable Remote Learning:
Press and hold SAT or Cable button on the GT-3.0 remote for
more than 3 seconds and repeat above learning steps 2-4.
To Next Page
Loading...
Need help?
General