To Next PageTo Next PageWhat to do if Genesis Grill burner does not ignite?
If the burner on your Genesis Grill doesn't ignite when you push the igniter button: 1. Remove any plastic wrapping from a new battery. 2. Check that a fresh battery is correctly installed. 3. Ensure wires are correctly inserted into the terminals on the ignition box. If match lighting works, the issue is with the ignition system.
Why are there flare-ups on my Genesis E-330 Grill?
Flare-ups in your Genesis Grill can occur for several reasons: * Ensure you preheat the grill correctly by setting all burners to HI for 10 to 15 minutes. * Thoroughly clean cooking grates, heat deflectors, and Flavorizer® bars if they're heavily coated with burned-on grease. * Clean the slide-out grease tray to ensure grease flows into the catch pan.
What to do if Genesis E-330 burner flame is low?
If the burner on your Genesis Grill does not light or the flame is low in the HI position, check if the fuel hose is bent or kinked. If so, straighten the fuel hose.
How to align cabinet doors on Genesis Grill?
If the cabinet doors of your Genesis Grill are not aligned, check the adjustment pin on the bottom of each door. Loosen the adjustment nut/s, slide the door/s until aligned, and then tighten the nut/s.
General| Main Burners | 3 |
|---|---|
| Cooking Grates | Porcelain-enameled cast iron |
| Ignition System | Electronic |
| Fuel Type | Liquid Propane |
| Warranty | 10 years |
Covers critical DANGER and WARNING blocks regarding gas leaks and fire hazards.
Provides extensive safety precautions for operating and handling the gas grill.
Procedures for testing gas connections to ensure leak-free operation.
Steps to take before performing gas leak checks, such as ensuring valves are off.
Instructions on how to remove the control panel and related parts for leak testing.
Step-by-step guide on how to check for gas leaks using soap and water solution.
Details leak checks for various specific gas line connections on the grill.
Procedures for inspecting the electronic igniter and fuel hose for proper function.
Step-by-step guide for igniting main burners using the electronic ignition system.
Step-by-step guide for manually igniting main burners using a match.
Instructions for igniting the Sear Station burner, both electronic and manual.
Specific troubleshooting steps for problems related to the side burner.
Guide to operating and troubleshooting the electronic ignition system, including wire connections.
