Quick Reference Guide I 28
27 I Quick Reference Guide
GENESIS G90
DRIVING
SHIFT BY ROTARY GEAR SHIFTER
IDLE STOP AND GO (ISG)
To change the gear, depress the brake
pedal and rotate the rotary gear shift dial.
A
P button
B
Rotary shifter (Rotary gear shift dial)
To shift the gear to P (Park), press the P
button while depressing the brake pedal.
Idle Stop and Go helps reduce fuel
consumption by automatically shutting
down the engine, when the vehicle is at
a standstill (for example, red stop light,
stop sign, and traffic jam) subject to
certain prerequisite conditions.
The engine is automatically started upon
satisfying the starting conditions.
A
B
ISG system is always active, when the engine is running.
Press the ISG OFF button to turn off ISG system. The ISG OFF button
indicator will illuminate. To use the system, press the ISG OFF button again.
ISG will default to on at every ignition on. Even if it was turned off at the last
engine off.
Air suspension uses the air spring
containing compressed air to adjust
and maintain the vertical height of the
vehicle both manually or automatically.
Each driving mode provides different
ride comforts.
Air suspension recognizes the driving
condition to automatically adjust
vehicle height, spring stiffness, and
shock absorber damping force for
driving comfort and vehicle protection.
AIR SUSPENSION (if equipped)
If you turn the vehicle off in R (Reverse), N (Neutral) or D (Drive), the gear will
automatically shift to P (Park).
SMART CRUISE CONTROL (SCC)
Turning on SCC
Setting vehicle distance
Increasing set speed
Decreasing set speed
Press the Driving Assist ( ) button to
turn on SCC. The speed will be set to
the current speed and the speed will be
displayed the cluster. The vehicle will
slow down as needed to maintain the
selected headway and will accelerate
and return to the speed you set when
that distance can be maintained.
SCC is designed to help detect the
vehicle ahead and help maintain the
desired speed and minimum distance
between the vehicle ahead.
Each time the button is pressed, the
headway changes as follows:
Push the + switch up and release it
immediately. The set speed will
increase by 1mph (1 km/h) each time
the switch is operated in this manner.
Push the - switch down and release it
immediately. The set speed will
decrease by 1mph (1 km/h) each time
the switch is operated in this manner.
B
A
Distance 2
Distance 3Distance 4
Distance 1
Note: Quick push up/down will
change speed by 1 mph. Holding
switch up/down will change the set
speed by 10 mph.
Temporarily canceling SCC
Press the switch or depress the
brake pedal to temporarily cancel
SCC.
A
Operating
B
Temporarily canceled
To Next Page
Loading...
