English
10" Compound Miter Saw
Operator’s Manual GMS1015LC
2
10" COMPOUND MITER SAW
Operator’s Manual
SPECIFICATIONS
• Model#:----------------------------------------------------- GMS1015LC
• Rated Power:----------------------------------------------- 120V~/ 60HZ, 15 Amp
• No Load Speed:-------------------------------------------- 4,600 RPM
• Blade Size: ------------------------------------------------- 10” (254mm)
• Arbor Size: ------------------------------------------------- 5/8”
• Bevel: ------------------------------------------------------ 45° Left
• Miter: ------------------------------------------------------ 45° Left and Right
• Max Cutting Capacity at 0° x 90°:-------------------------- 3” H x 4-3/4” W
• Max Cutting Capacity at 45°x90°: ------------------------- 3” H x 3-5/16” W
• Max Cutting Capacity at 0°x 45°: -------------------------- 1-3/8” H x 4-3/4” W
• Max Cutting Capacity at 45°x45°: ------------------------- 1-3/8” H x 3-5/16” W
• Net Weight: ------------------------------------------------- 24 Lbs
• Laser: -- Class II Laser, Wave Length: 650 nm, Max Output <1.0 mw
Includes: Saw, 60T Carbide Tipped Blade, Hold Down Clamp, Dust Bag, 2-Extension Wings, 2-AAA
Batteries for Laser and Wrench
WARNING: To reduce the risk of injury, user must read and understand this
operator’s manual before operating this tool. Save this Manual for future reference.
Toll-Free Help Line: 1-888-552-8665
WARNING: The Operation of any power tool can result in foreign objects
being thrown into your eyes, which can result in severe eye damage. Before beginning
tool operation, always wear safety goggles or safety glasses with side shields and a
full face shield when needed. We recommend Wide Vision Safety Mask for use over
eyeglasses or standard safety glasses with side shields. Always wear eye protection
which is marked to comply with ANSI Z87.1.
Look for this symbol to point out important safety
precautions. It means attention!!! Your safety is involved.
GENERAL SAFETY RULES
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and
other construction activities contains chemicals known to cause cancer, birth defects or
other reproductive harm. Some examples of these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement and other masonry products, and
• Arsenic and chromium from chemically treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your
exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as
those dust masks that are specially designed to filter out microscopic particles
.
WEAR YOUR
FORESIGHT IS BETTER
THAN NO SIGHT
SAFETY GLASSES
To Next Page
Loading...
Need help?
General
