Genesis GTS10SB - Page 7

7
English
• Alwayssecuretheworkpieceagainstripfenceormitergauge.
• Alwaysusepushstickforrippingnarrowstocksoyourhanddoesnotcome
closetothesawblade. Useapushblockorfeatherboardfornon-throughcuts
• Nevercutfreehand,whichmeansusingonlyyourhandstosupportorguidethework
piece.Alwaysuseripfenceormitergaugetopositionandguidethework
• Standtothesideofthebladeandworkpiece.NEVERstandorhandanypart
ofyourbodyinlinewiththepathofthesawblade.
• Neverreachbehindbladewhenthesawbladeisrotating.
• Moveripfenceoutofthewaywhencrosscutting.NEVERuseripfenceasa
cutoffgaugewhencrosscutting
• Keepsawbladecleanandsharp.ADullandstickybladewillincreasetheriskof
bindingintheworkpiece.
• FeedtheworkpiecethroughAGAINSTtherotationoftheblade.
Feedingmaterialfromthebackofthesawinvitesanaccidentandcancauseseriousinjury.
• Use support for the sides and back of the saw table when cutting
wide or long work piece.
• Nevercutmorethanoneworkpieceatatime.Stackedworkpiecescanshift
orbindandleadtounexpectedcontactwithblade.
• Keepripfenceparalleltothesawbladetoavoidbindingor
kickbacks.
• Neverpulltheworkpiecethroughthespinningblade.Itmaycause
kickbackandcauseseriouspersonalinjury.Youcanbedraggedintothebladesduringa
kickback.
• Donotripaworkpiecethatistwistedorwarpedordoesnothavea
straight edge to guide along the fence.
• Nevermakethroughcutsnarrowerthan½”.Thebladeguardsystemisnot
effectivefornarrowripcutsandwillnotpreventkickback.
• Neverattempttofreeastalledsawbladewithoutturningoffthe
saw and unplugging the saw from the power source.
• Avoidcuttingnailsorothermetalpieces.Inspectforandremoveallnailsfrom
theworkpiece.
• Alwaysturnthesawoffbeforeunpluggingthesawfromthepower
source toavoidaccidentalstartingwhenre-pluggingintotothepowersource.Neverleave
thetablesawunattendedwhileconnectedtoapowersource.
• Useonlyaccessoriesratedforthespeedrecommendedonthetool
warning label or higher. Thebladeforthistablesawmustbe10”(254mm)indiameter,
ratedatleast4,800rpmorhigherwith5/8”arbor.Accessoriesrunningatspeedsgreaterthan
ratedcanyapartandcausepersonalinjury.
• Savetheseinstructions.Refertothemfrequentlyandusetoinstructotherusers.