Genesis GTS10SC - Page 13

13
English
To adjust 90° positive stop
 
 

 

 


 

 

To adjust the 45° positive stop, 


WARNING: To prevent personal Injury, always unplug the saw from the power
source before make any adjustments.
BLADE BEVEL INDICATOR ADJUSTMENTS (FIG 16)
 

 
NOTE:
BLADE BEVEL ADJUSTMENT (FIG 16)
 
 

 
 WARNING:Make sure bevel locking lever is tightened before each use to
avoid risk of personal injury.
TO REPLACE THE BLADE (FIG 18)
WARNING: Always unplug the saw from power source before maintenance to
avoid risk of serious personal injury.
To remove the blade:
 
 
    

 
 

 
To install the blade,
IMPORTANT:Blade rotation is counter-clockwise when observing from the right side
of the saw. Make sure the rotation direction mark on blade matches with that.
FIG 17
FIG 18
b
a