Genesis GTS10SC - Table Saw Specific Safety

5
English
 

 
SPECIFIC SAFETY RULES FOR TABLE SAWS
WARNING: DO NOT LET COMFORT OR FAMILIARITY WITH PRODUCT
(GAINED FROM REPEATED USE) REPLACE STRICT ADHERENCE TO PRODUCT SAFETY
RULES. If you use this tool unsafely or incorrectly, you can suffer serious personal injury!
 Do not cut metals with the table saw. 


• Toavoidtippingyourtablesawinoperation,rmlyboltittoaworkstandorbench.

• Unplugsawfrompowersourcebeforemakingadjustments,repairs,maintenanceor
storing. 
• Donotturnonthetablesawbeforeclearingthetableofalltools,woodscraps,

• Weareyeandhearingprotection.



• Protectyourlungs.Wearfaceordustmask.

• Tiebacklonghairandrolllongsleevesabovetheelbow.


• Alwaysusebladeguard,splitterandanti-kickbackpawlsonallthroughcutting
operations. 

• Alwayssecuretheworkpieceagainstaripfenceormitergauge.
• Alwaysuseapushstickforrippingnarrowstock
. 
• Nevercutfreehand,

• Standtothesideofthebladeandworkpiece.

• Neverreachbehindthebladewhenthesawbladeisrotating.
• Movetheripfenceoutofthewaywhencrosscutting.

• Keepthesawbladecleanandsharp.

• Feedtheworkpiecethroughagainsttherotationoftheblade.

Recommended Minimum Wire Gauge for Extension Cords (120 Volt)
Nameplate
Amperes
(At Full Load)
Extension Cord Length
25 Feet 50 Feet 75 Feet 100 Feet 150 Feet 200 Feet
0–2.0      
2.1–3.4      
3.5–5.0      
5.1–7.0      
7.1–12.0      
12.1–16.0      
16.1–20.0      