Genesis GTS10SC - Page 6

English
10" Table Saw
Operator’s Manual GTS10SC
6
 Use support for the sides and back of the saw table 
• Nevercutmorethanoneworkpieceatatime.

• Keepripfenceparalleltothesawbladetoavoidbindingorkickbacks.
• Neverpulltheworkpiecethroughthespinningblade.

• Donotripaworkpiecethatistwistedorwarpedordoesnotave a straight edge to
guide along the fence.
• Nevermakethroughcutsnarrowerthan1/2”.

• Neverattempttofreeastalledsawbladewithoutturningoffthesawandunplugging
the saw from the power source.
• Avoidcuttingnailsorothermetalpieces.
• Alwaysturnthesawoffbeforeunpluggingthesawfromthepowersource


• Useonlyaccessoriesratedforthespeedrecommendedonthetoolwarninglabelor
higher. 

• Savetheseinstructions.
SAVE THESE INSTRUCTIONS
GLOSSARY OF WOOD-WOKING TERMS
Work Piece 
Anti-Kickback Pawls 

Arbor 
Bevel Cut 
Compound Miter Cut
Cross Cut 
Dado
Feather board

Freehand

Gum
Heel

Kerf

Kickback


Leading End

Miter Cut
Molding
Non-Through Cut

Push Block
