Need help?Do you have a question about the Genie GCG350ML and is the answer not in the manual?
General| Brand | Genie |
|---|---|
| Model | GCG350ML |
| Category | Garage Door Opener |
| Language | English |
Verify suitable ceiling location and mounting plan for the power head.
Ensure the wall above the garage door provides a strong mounting point for the header bracket.
Confirm clear path and wood surface for Safe-T-Beam system brackets.
Identify door material and need for additional bracing on lightweight doors.
Confirm a 110-120 Volt power supply is accessible near the mounting area.
Ensure all existing door locks are disabled to prevent operator damage.
Verify the garage door is properly balanced and moves freely.
Evaluate the need for an emergency release kit if no separate garage entry door exists.
Instructions for identifying, arranging, and connecting rail sections and clamps.
Steps for attaching carriage, emergency release, and first limit switches.
Routing and connecting limit switch wires to the power head terminals.
Locating and mounting the header and door brackets to the garage structure.
Positioning and securing the operator assembly to the ceiling or support structure.
Attaching and connecting the door arms for both sectional and 1-piece doors.
Mounting STB brackets, source, sensor, and wiring the safety system.
Finding a location, wiring, and mounting the wall control unit.
Instructions for plugging into a grounded outlet or permanent wiring.
Setting door travel limits and adjusting opening/closing force.
Steps for programming single-button remotes and basic operation.
Replacing remote battery, installing lens, and replacing light bulb.
Critical safety guidelines for operation and preventing injury.
Monthly maintenance tasks and self-diagnostic for Safe-T-Beam system.
Diagnosing and resolving common operator issues and malfunctions.
Electrical wiring schematic and transmitter compliance information.
Details on product coverage, limitations, and how to obtain service.
To Next Page
