GenInterlock ITE-200A User Manual

Model
ITE-200A
Description
Generator interlock kit Siemens, Gould and ITE, 150 and 200 Amp
Panels
Main Breaker
150 or 200 amp Vertical throw up (on) down (off)
Generator Breaker
Top left side 2 positions
WARNING
Only qualified personnel should be working on the panel box
An amateur should NEVER open the panel box
Please follow all rules and regulations of the National Electric Code
Step 1: Disassemble the interlock. Place the bottom plate (holes only) above the top left breaker and mark holes.
Step 2: Turn off main breaker and remove panel cover.
Step 3: Drill holes as marked on panel cover with supplied 3/16 drill bit and remove all burs from drilling cover.
Step 4: Insert screws from rear of cover, install bottom plate, and install top plate (slotted) install thread lock to screws and install
retaining nuts. Ensure proper movement.
Step 5: Install 2 pole Generator breaker on top left side and place Generator Warning Sticker on Generator breaker.
Step 6: Combine the zip ties to make a loop and install zip ties around top set of breakers in panel as shown in picture below. Pull on
ends to make tight around breakers. Install Warning label next to release tab on zip tie at generator breaker.

GenInterlock ITE-200A Specifications

General

Brand	GenInterlock
Model	ITE-200A
Category	Circuit breakers
Language	English

Summary

Generator Interlock Kit Product Details

Model Number

Identifies the specific model of the generator interlock kit.

Kit Description and Compatibility

Details the kit's compatibility with various panel brands and amp ratings.

Main Breaker Specifications

Describes the main breaker type, amperage, and operational throw.

Generator Breaker Placement

Indicates the recommended position and type for the generator breaker.

Safety Warnings and Installation Guide

Critical Safety Warnings

Stresses that only qualified personnel should work on the panel box.

Installation Steps

Provides a step-by-step guide for installing the generator interlock kit.

Post-Installation Verification and Labels

Operation Verification

Details how to verify the proper operation of the interlock after installation.

Required Labels

Specifies placement for generator start-up and caution labels.

Disclaimer and Support Information

Product Disclaimer

States the company's non-responsibility for misuse or improper installation.

Contact Information

Provides website, email, and phone number for support.