GENMAX GM3200i - Starting Up the Generator

12
STARTING UP THE GENERATOR
Remove the load from all output ends;
1.
Switch ECO switch to "OFF";
2.
Turn ventilation knob of fuel tank cap to "ON";
(GM2200i only)
3.
Turn combination switch control to "CHOKE" position;
Tip: When hot engine is started up, it is unnecessary to close the choke
valve, but turn the combination switch to "RUN".
4.
First gently pull startup handle, until guy cable is hooked tight, and then pull
it with effort.
Tip: When pulling the hand starter, hold generator carrying handle firm, to
prevent the generator from overturning.
5.
After the generator starts, turn the three-in-one switch to "RUN".
6.
Plug in after started.
7.