19
SERVICE AND MAINTENANCE
Place an oil pan under the engine, tilt the generator to quickly pour out oil;
After discharging the oil, put the generator back on level ground;
4.
Refill oil to a proper level, tighten oil dipstick,
cover external cover plate and tighten the knob.
5.
Don't go over the scale
Recommended oil: SAE S10W/30
Oil grade: API standard Model SJ or higher
Volume: GM2200i:0.1gal
GM3200i/GM3300i:0.12gal
Air filter
4
Dirty air cleaner may prevent air from flowing into the carburetor. In order to prevent failure of the carburetor,
please maintain air cleaner regularly. If being used in a dusty environment, it shall be maintained frequently.
Unscrew the knob , to remove cover plate of air cleaner;
1.
Remove screws , to remove cover plate of air
cleaner ;
2.
Clean foam cleaner element with cleaning solvent and blow it dry, Put a few
drops of oil on the filter element.
3.
ATTENTION
Be sure not to twist the foam cleaner element forcibly to avoid
damage.
Put foam cleaner element into air cleaner;
Tip: Make sure that the surface of foam cleaner element is in close contact
with air cleaner, and there shall be no gap leaking air. Be sure not to start the
engine before air cleaner is assembled, because it will generate excessive
toxic gas and wear the cylinder;
4.
To Next Page
Loading...
