Need help?Do you have a question about the Genmitsu 3030-PROVer MAX CNC and is the answer not in the manual?
General| Model Name | 3030-PROVer MAX |
|---|---|
| Control Board Compatibility | GRBL 1.1h |
| MCU | 32-Bit |
| Leadscrew | 1204 Ball Screw |
| Motion System | HG15 Linear Guide & Ball Screw |
| Spindle Motor | 48VDC 300W |
| Stepper Motor | 1.68A, 0.45Nm torque |
| Max Speed | 2000mm/min |
| CAM Software | Software Based on GRBL Firmware, e.g. Candle, UGS, GrblControl (Candle) |
| Power Supply | AC110/230V（Switch Power） |
Weight and Dimensions| Work Area | 300 x 300 x 78mm (11.81” x 11.81” x 3.07”) |
|---|---|
| Overall Dimensions | 544 x 523 x 412mm (21.42" x 20.59"x 16.22") |
| Frame Material | All Aluminum |
To Next Page