Genmitsu 4040-PRO MAX - Mechanical Installation

08
Mechanical Installation
STEP 1 Installing Rubber Feet
1. Peel off the release paper from the 4 rubber feet.
2. Attach the 4 rubber feet to the bottom grooves at the ends of the front and rear aluminum profiles.
3. Then place the front and rear aluminum profiles attached on a flat table as shown.
Rear Aluminum Profile
The Bottom Grooves
at the Profiles
Front Aluminum Profile
(4) Rubber Feet
Front Aluminum Profile
(4) Rubber Feet
Rear Aluminum Profile
What you need: