Need help?Do you have a question about the Geo Knight DK3 and is the answer not in the manual?
General| Weight | 98 lbs |
|---|---|
| Voltage | 120V |
| Type | Heat Press |
| Temperature Range | 0-450°F |
| Pressure Adjustment | Adjustable |
| Power | Electric |
| Timer | Digital |
Displays current temperature and time, and heating/timing status.
How to adjust the desired temperature using the TEMP and Arrow keys.
Procedure to set the main timer using the Arrow keys.
Explains the secondary timer for multi-step processes and how to activate it.
How to adjust the pressure knob to accommodate different mug sizes.
Key considerations for proper pressure adjustment and clamping.
Use of extra padding for smaller diameter items.
Information on when and how to replace worn green pads.
Explains the function and storage of temperature, time, and pressure settings.
Steps to select and apply a pre-programmed setting.
Method to access advanced settings and configurations.
Switching between temperature display units (°F or °C).
Configuring timer units between minutes/seconds and hours/minutes.
How the press tracks and resets the cycle count.
Note that this menu item is not applicable to the DK3 model.
Note that this menu item is not applicable to the DK3 model.
Setting alarms for significant temperature drops during operation.
Option to enable or disable the audible feedback from key presses.
Customizing different audible alarm patterns for timer alerts.
Enabling a beep notification in the final seconds of a cycle.
Turning the Prepress timer feature on or off.
Adjusting alarm patterns specifically for the Prepress timer.
Feature to prevent unauthorized changes to controller settings.
List of available spare parts for the DK3 heat press.
Routine checks and part replacement guidance for optimal operation.
Issues with timer activation and reset related to the tilt sensor or wiring.
ERR display indicates a loss of heating signal or a failed sensor.
Troubleshooting lack of response or sound from the keypad.
Long heat-up times indicate potential heater band failure.
Addresses print quality issues like white spots or faded areas.
Solutions for white lines or streaks, including mug curvature and heater band leveling.
Problems with pressure adjustment related to spacer washers.
To Next Page
