4
Setup & Suggestions
• Locate the press on a firm, sturdy work surface. Non-skid rubber
matting is especially helpful to keep the press from sliding on the
worksurface.
• The height of the bench/work space the press is located on would be
ideally 27” to 32” high. The higher the press, the more difficult to
close/lock.
• Attach the power cord from the rear to the backside of the controller.
There is a power inlet on the back panel of the control box for the
power cord.
• Make sure the power cord can not be pulled on. Make sure there is no
tension on the inlet socket that the power cord plugs into
• The press can be left in the opened or closed position. There is no
difference in heating/performance. At certain pressure settings, the
handle may rest in the closed position. This is not a problem.
To Next Page
Loading...
