Geometrics Inc. G-882 Cesium Marine Magnetometer Page
Cm201Set.bat
This batch asks the user questions and based on the answers to these
questions creates a batch file called "Cm201.bat". The questions include such
things as, to which COM port the CM-221 counter is connected.
Cm201.bat
This batch file is created by Cm201set.bat. It invokes Cm201go.exe to send
any command lines necessary to correctly configure the CM-221 counter(s) for
the users application.
Cm201go.exe
This program is intended to send any commands to correctly configure the CM-
221 counter module(s). Normally the commands are taken from the file
Cm201go.cnf, but this can be overridden if needed.
The calling syntax for this program is:
Cm201go FileName.cnf /b:BBBBB /p:P /i:I /d:D
Where:
BBBBB Is the baud rate that the CM-221 starts at. Normally this is
9600.
P The port number /p:1 would mean use COM1. This
parameter is optional. If it not specified COM1 will be used.
I The interrupt number to use. This parameter is optional. If
it is not specified the normal interrupt for the COM port is
used.
D Any value other than zero will turn on the debugging
display. This parameter is optional. If it is omitted the
debugging display is disabled.
The contents of the Cm201go.cnf file are sent line by line to the CM-221
counter module(s). After each line is sent the CM201go program waits for the
confirmation that the command was received correctly. If the confirmation is
not received the line is repeated. For lines that change the CM-221's baud rate
the Cm201go program changes its baud rate as required. If the input line has
the special code "[CLOCK]" on it, the CM-221's clock will be set to match that of
the PC.
A typical Cm201go.cnf would be:
To Next Page
Loading...
Need help?
General