Geometrics Inc. G-882 Cesium Marine Magnetometer Page
counters and will cause a brief adjustment period until each counter determines
where it stands in the daisy chain. Thus there will be a short period of garbled
transmissions to the logging PC upon power-up or reset.
4.5 Accessory Software
4.5.1 Cesium Sensor Active Zones – CSAZ
A newly designed CSAZ Windows™ program is available on our Magnetometer
CD and from our FTP site at ftp://geom.geometrics.com/pub/mag/Software/
(look for csaz-setup.exe). Please read the manual that is included with the
program for complete instructions on how to use the CSAZ program for
worldwide inclination and sensor orientation solutions.
4.5.2 CM201
Note: Cm201 and View201 are DOS software and compatible with CM-221
counters. They are installed from the Magnetometer CD under Utilities. Some
modern computers may not run these DOS programs correctly.
Cm201 is a program that facilitates sending a command start-up file to the
G−882 counter(s) and initiating system operation. The program is executed by
typing “cm201” at the DOS prompt and pressing return. Cm201 expects a
counter command file that must be called Cm201go.cnf. This file is a list of
counter commands, each followed by a carriage return that may be required to
configure the counter to your application.
This software and all its necessary files may be installed on your system by
placing the Install disk in either your a: or b: floppy drive, switching to that drive,
typing “install” at the DOS prompt and pressing return. Install will ask a number
of questions to which you should respond to configure the CM-221 counter to
your system and create the Cm201go.cnf file.
If, after installing Cm201, if further commands are required (such as CLOCK) to
configure CM-221 operation to your application, they may be added to the
Cm201go.cnf file by editing this file with any suitable text editor.
The following describes Cm201 and the files that will be installed on your C:
drive:
Install.bat
This is a batch file used to copy the contents of the Utility Software onto your
hard disk. A directory called "GeoUtil" is created on the "C" drive and then all
of the files are copied into that directory. After the files are copied, this batch
file then runs Cm201set.bat
To Next Page
Loading...
Need help?
General