16
7) After ignition, preheat the grill and cooling surface by turning the regulator knob to
“High” for about 8 minutes.
WARNING: If the burner goes out while cooking, turn the regulator knob to
the “OFF” position. Wait five minutes before attempting to relight the grill.
MANUAL LIGHTING OF THE GRILL
Note: If the flame is accidentally extinguished, repeat the procedure below for lighting the
grill. (See also TROUBLESHOOTING)
WARNING!
• Open the grill lid before lighting the burner to prevent an explosion from
gas buildup.
• Always inspect the regulator/tube assembly before each use. If it is bent, cut or
damaged, do not use the LP gas grill. Contact Consumer Support, as the regulator
assembly must be replaced with an assembly specified by the manufacturer prior to
the further use of the LP gas grill.
How to manually Light your LP Gas Grill
1) Open the grill on a table top or level surface.
2) Turn the regulator knob counterclockwise from the OFF/LOCK position, push in and turn
to “High“. (FIG 16A)
3) Insert a lit match on the match holder through the match lighting hole at the front, right
side of the grill (FIG 16B)
4) Turn the regulator knob from “HIGH” to “LOW”, while checking the flame through the
match light hole to make sure it is lit.
5) If burner does not light, turn regulator knob to OFF/LOCK. Remove the cooking surface
to dissipate the gas. Wait five minutes then repeat steps 2 thru 4.
6) If burner still fails to light, wait five minutes and refer to the TROUBLESHOOTING.
Fig. 16a
Fig. 16b
Match
holder
Match
lighting hole
To Next Page
Loading...
Need help?
General
