99 Cancel the
action:
Remove the
uplink data limit
action on the
modem.
100 Cancel the
action:
Remove the
limit action on
the Modem of
level 2.
105 Cancel the
action:
Remove the
limit action
on the Wi-Fi
AP of level 3.
111 Cancel the
action:
Remove the
limit action of
level 4.
WARNING! All in-vehicle devices and related cabling must be securely fastened and kept clear of all vehicle controls, including
gas, brake and clutch pedals. This requires the use of a cable tie when securing the device or any extension harness to the OBD
connector, securing both sides of the harness. If you do not use a cable tie, vibration in the vehicle can lead to a loose
connection which could indirectly cause the vehicle’s engine computer to fail, loss of vehicle control and cause serious injury.
Inspect devices and cabling regularly to ensure all devices and cables remain securely attached.
WARNING! If at any point after an in-vehicle device is installed a warning lights up on the vehicle dash or the vehicle stalls or has
a marked drop in performance, shut off the engine, remove the device, and contact your reseller. Continuing to operate a vehicle
with these symptoms can cause loss of vehicle control, and serious injury.
Important safety information and limitations of use
For the latest version of the Limitations of Use, please visit: goo.gl/k6Fp0w.
WARNING! Your in-vehicle devices must be kept clear of debris, water and other environmental contaminants. Failure to do so
may result in units malfunctioning or short-circuiting, that can lead to a fire hazard and cause loss or serious injury.
WARNING! Do not attempt to remove the devices from the vehicle in which they are originally installed for installation in another
vehicle. Not all vehicles share compatibility, and doing so may result in unexpected interactions with your vehicle, including
sudden loss of power or shutdown of the vehicle’s engine while in operation or cause your vehicle to operate poorly or erratically
and cause serious injury and/or vehicle damage.
NOTICE: This product does not contain any user-serviceable parts. Configuration, servicing, and repairs must only be made by
an authorized reseller or installer. Unauthorized servicing of these products will void your product warranty.
NOTICE: The EU Declaration of Conformity is available at
https://gtb.page.link/pMwn.
Regulatory statements
Warning: RF exposure compliance
The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons
and must not be co-located or operating in conjunction with any other antenna or transmitter. Users and installers must be
provided with antenna installation instruction and transmitter operating conditions for satisfying RF exposure compliance.
L'antenne ou les antennes utilisées pour cet émetteur doivent être installées pour fournir une distance de séparation d'au moins
To Next Page
Loading...
