EasyManua.ls Logo

Geotech SP 520E - DESCRIPTION OF THE UNIT

Default Icon
63 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
30
Perform all cleaning and maintenance with the unit turned off.
It is forbidden to remove the protective devices while the unit is moving.
It is forbidden to direct the jet or liquid towards people and/or animals.
It is forbidden to fill the tank to the very top.
It is forbidden to dump the residual products in the environment alter use.
Only loan your sprayer to expert users who are completely familiar with sprayer operation and
correct use.
Give the manual with operating instructions which they should ready before using the sprayer.
Permit only skilled personnel to perform maintenance and/or repairs to the tank.
Permit only skilled personnel to change the oil in the pump.
Permit only skilled personnel to check and/or change the pump pistons or membranes.
The sprayer must always be kept upright to prevent liquid escaping from the tank
DESCRIPTION OF THE UNIT
This unit complies with the fundamental safety and health requirements contained in EEC Directive 2006/42
and subsequent modifications.
This unit is a knapsack or trolley sprayer with a hand-held spray nozzle (or with an optional boom)
that produces a spray of fine droplets due to the hydraulic pressure generated by the pump. It
consists of a frame, a polyethylene tank; and a pump with corresponding hydraulic circuits. The
polyethylene tank is equipped with a graduated level scale.
The cap on the bottom of the tank can be used to discharge it.
The high - pressure positive-displacement pump is operated directly by the electric motor or explosion engine.
The pump draws the product out of the tank and transfers it under pressure to the spray nozzle.
-The regulation system operates at constant pressure. The operating pressure is measured on the graduated
scale located on the control unit.
Always make sure that the unit is in a stable position so as to avoid it tipping over.

Related product manuals