STARTING THE UNIT
1) PREPARE THE CHEMICAL SOLUTION IN A DIFFERENT CONTAINER THAT
MAY USE.
2) IMPORTANT DUST SOLUBLE IN WATER MUST COMPLETE FLUID BEFORE
TO PUT INSIDE THE TANK
→ ATTENTION:
The pump is suitable only for liquids eventually with solids in suspansion. Mix with care the
product before filling the tank and use alwais the proper filter placed below the cover.
3) FILL THE TANK.
4) CLOSED HERMETICALLY THE TANK CAP
5) THE TANK CAP MUST ALWAYS CLOSED DURING THE WORKING.
6) SWITCH ON TUE BUTTON OR START THE ENGINE.
7) CHECK DURING THE USE THAT THERE AREN’T ANY LOSS FROM PIPINGS OR COUPLINGS
8) OPEN THE SPRAY NOZZLE.
IMMEDIATELY AFTER THE USE CLEAN CARREFULLY THE PUMP INSIDE AND THE
WHOLE CIRCUIT BY PUTTING CLEAN WATER IN THE TANK AND MAKING THE ENGINE
RUNNING WITH OPEN LANCE
ENGINE VERSION: SEE INSTRUCTIONS ON THE PUMP AND ENGINE MANUAL USE
To Next Page
Loading...
