Need help?Do you have a question about the GeoVision GV-AS810 and is the answer not in the manual?
General| Model | GV-AS810 |
|---|---|
| Input Voltage | 12V DC |
| Communication Interface | TCP/IP, RS-485 |
| Event Log Capacity | 100, 000 |
| Number of Readers Supported | 2 |
| Number of Inputs | 4 |
| Type | Access Controller |
| Reader Type | Wiegand |
Step-by-step guide for installing the GV-AS100 / 1010 controller and connecting hardware components.
Instructions for entering programming mode, managing cards, and configuring controller settings.
Guide for installing the GV-AS110 / 1110 controller, including wiring and connections.
Steps for programming the GV-AS110 / 1110, including card management and command codes.
Wiring and installation guide for the GV-AS120 controller.
Instructions for programming the GV-AS120, including card management.
Guide for installing GV-AS210 / 2110 / 2120, including reader and device connections.
Installation and connection guide for GV-AS410/4110/810/8110 controllers.
Guide for installing the GV-EV48, including connecting readers, relays, and power.
Detailed configuration of door, Wiegand, alarms, time, and I/O functions.
Steps to resolve internet connectivity issues between software and controllers.
Troubleshooting guide for interrupted controller connections due to IP conflicts.
Resolving issues with card message reception while reader connection is active.
Troubleshooting card format compatibility issues causing access denial.
To Next Page
