Need help?Do you have a question about the GeoVision GV-AS210 and is the answer not in the manual?
General| Interface | RS-485 |
|---|---|
| Case design | Bare |
| Built-in UPS | - |
| Number of users | 40000 user(s) |
| Maximum number of doors | 4 door(s) |
| Number of Wiegand readers supported | 4 |
| Power consumption | 200 mA |
| Operating temperature (T-T) | 0 - 65 °C |
| Operating relative humidity (H-H) | 10 - 90 % |
Weight and Dimensions| Depth | 46.6 mm |
|---|---|
| Width | 210 mm |
| Height | 204 mm |
| Weight | 810 g |
Provides instructions and diagrams for installing the GV-AS100/1010 controllers.
Explains how to connect Wiegand, RS485, and Network card readers to the controllers.
Instructions for establishing communication between the controllers and a PC.
Steps for supplying power to the GV-AS100/1010 controllers using the provided adapter.
Describes how to enter and use the programming mode for controller setup.
Details the procedures for enrolling and removing access cards from the system.
Covers configuring various operational parameters for the controllers.
Procedure to reset the controller's settings back to factory default values.
Technical specifications for the GV-AS100 and GV-AS1010 controllers.
Provides instructions and diagrams for installing the GV-AS110/1110 controllers.
Explains how to connect Wiegand and Network card readers to the controllers.
Instructions for establishing communication between the controllers and a PC.
Steps for supplying power to the GV-AS110/1110 controllers using the provided adapter.
Describes how to enter and use the programming mode for controller setup.
Details the procedures for enrolling and removing access cards from the system.
Covers the command codes and procedures for programming controller functions.
Technical specifications for the GV-AS110 and GV-AS1110 controllers.
Provides instructions and diagrams for installing the GV-AS120 controller.
Explains how to connect a Wiegand reader to the GV-AS120 controller.
Instructions for establishing communication between the GV-AS120 and a PC.
Describes how to enter and use the programming mode for controller setup.
Details the procedures for enrolling and removing access cards from the system.
Technical specifications for the GV-AS120 controller.
Provides instructions and diagrams for installing the GV-AS210/2110/2120 controllers.
Explains how to connect Wiegand and RS485 card readers to the controllers.
Instructions for connecting a backup battery for power continuity.
Steps for supplying power to the GV-AS210/2110/2120 controllers.
Instructions for establishing communication between the controllers and a PC.
Technical specifications for the GV-AS210, GV-AS2110, and GV-AS2120 controllers.
Provides instructions and diagrams for installing the GV-AS410/4110/810/8110 controllers.
Explains how to connect Wiegand and RS485 card readers to the controllers.
Technical specifications for the GV-AS410/4110/810/8110 controllers.
Explains how to connect GV-Readers and GV-GF readers via RS-485.
Technical specifications for the GV-EV48 controller.
Steps for configuring a static IP address for network access.
Configuration options for door, Wiegand, alarms, time, and I/O functions.
Solutions for connectivity problems, IP conflicts, and advanced setting access issues.
To Next Page
