Need help?Do you have a question about the GeoVision GV-AS1010 and is the answer not in the manual?
General| Model | GV-AS1010 |
|---|---|
| Input Voltage | 12V DC |
| Communication Interface | RS-485, TCP/IP |
| Number of Events | 100, 000 |
| Operating System | Linux |
| Network Interface | 10/100 Mbps Ethernet |
| Door Control | 1 Door |
| Reader Support | 2 Readers |
| Power Supply | 12V DC, 1A |
Step-by-step guide for installing the GV-AS100 / 1010 controller and its components.
Instructions for entering programming mode, adding/deleting cards, and setting parameters.
Wiring and installation instructions for GV-AS110 and GV-AS1110 controllers.
Guide to programming GV-AS110 / 1110, including card management and settings.
Installation and wiring guide for the GV-AS120 controller.
Steps for programming the GV-AS120 controller, including card management.
Guide for installing and connecting readers, input/output devices, and power for the controllers.
Instructions for connecting card readers, input/output devices, backup battery, and power.
Instructions for connecting readers, output relays, backup battery, power, and PC.
Steps to configure a static IP address for controller network access.
Configuration of door/Wiegand operations, alarms, time, and input/output functions.
Troubleshoots GV-ASManager connection issues with controllers over the internet.
Addresses problems with interrupted connections between GV-ASManager and controllers.
Solves issues with reader messages, DVR playback, and invalid card errors.
To Next Page
