GV-AS120 Controller
69
3
3.3 Programming Mode
After powering on GV-AS120, you must create two cards first, an Enroll Card and a Delete
Card. The Enroll Card is used for adding new cards and the Delete Card is used for deleting
cards. Either card will allow you to program the various configurations on GV-AS120.
Note: The card complying with ISO 14443A standard for smart card technology can be
formatted as an Enroll Card or Delete Card.
To create the Enroll Card and the Delete Card:
1. Power on the unit. The LED flashes blue.
2. Present a card to be the Enroll Card.
3. Present a card to be the Delete Card.
4. The GV-AS120 will automatically load default, and the LED will flash blue and yellow.
After 1 to 2 minutes, the LED should be a constant blue light to indicate READY.
3.3.1 Adding and Deleting Cards
Using the two cards, you can add new cards to GV-AS120 and delete existing cards on GV-
AS120.
Note:
1. GV-ASManager cannot manage the cards enrolled on GV-AS120, since the card data
will not be transmitted to GV-ASManager.
2. The cards added through GV-ASManager cannot be deleted on GV-AS120.
To Next Page
Loading...
Need help?
General
