GeoVision GV-AS1010 User Manual

GV-AS410 / 4110 / 810 / 8110 Controller
101
5
5.2.3 Connecting Output Devices
Up to 24 output devices can be connected to GV-AS410 / 4110 / 810 / 8110. Check if your
output device meets the following absolute maximum ratings before connecting it to output
terminal block.
Outputs Outputs 1-16 Outputs 17-24
Breakdown Voltage
110V AC – 250V AC, 30V DC 30V DC
Continuous Load Current
3A (AC), 3A (DC) 1A
Note: Absolute Maximum Ratings are those values beyond which damage to GV-
AS410 / 4110 / 810 / 8110 circuit board may occur. Continuous operation at the
absolute rating level may affect GV-AS410 / 4110 / 810 / 8110’s stability.
To connect an output device:
Connect the (+) point on the output device to COM on GV-AS410 / 4110 / 810 / 8110,
connect the two (-) points of the output device and the power supply together, and connect
the (+) point on the power supply to the NO or NC of GV-AS410 / 4110 / 810 / 8110 based
on the state of the output device.
There are two ways to supply power to the output device:
 Use the power outputs on the GV-AS Controller: The total power consumption of the
output devices and readers connected to GV-AS Controller must be under 3.5A for GV-
AS410 / 4110 or 5A for GV-AS810 / 8110. The output device must be a 12V device.
 Connect an external power supply: Connect an external power supply if the total
power consumption exceeds 3.5A / 5A or if the output device requires higher current.
External
Power
Supply
OUT2
OUT1
NO
COM
NC
NO
COM
NC
12V OUTPUT
12V
GND
12V
GND
12V
GND
OUT2
OUT1
NO
COM
NC
NO
COM
NC
Output
Device
Output
Device
Figure 5-5
Note: If you want to use the power outputs on the GV-AS Controller, note that the maximum
current of the individual voltage output is 12V, 0.9A.

GeoVision GV-AS1010 Specifications

General

Brand	GeoVision
Model	GV-AS1010
Category	Controller
Language	English