GV-AS100 / 1010 Controller
19
1
1.2.7 Using the Function Keys (GV-AS1010 Only)
GV-AS1010 comes with four function keys for time and attendance records. On the Web
interface of GV-AS1010, you can define function keys. Refer to the Function Key section in
Chapter 8.
Before employees present their access card to GV-AS1010, they can press the function
keys to indicate the card swipe is the start or end of Work Time, Away, Overtime, Break
Time or Job Code. You can look up the attendance data in GV-TAWeb. Refer to the GV-
TAWeb for Workforce Schedule and Payroll chapter in GV-ASManager User’s Manual for
details.
On the Web interface of GV-AS1010, you can specify whether or not the door or elevator
call button will unlock when an access card is presented after a function key is pressed.
Refer to the Function Key Configuration section in Chapter 8 to see the related settings.
Figure 1-15
Note: When using GV-AS1010 firmware V1.0, presenting the access card after pressing a
function key will not unlock the door or elevator call button. The user will need to present
the access card again to gain access.
To Next Page
Loading...
Need help?
General
