Getting Started
7
2
2.2 Adding Hosts
Note: To connect to GV-DVR / NVR / VMS hosts, make sure Control Center Service and
Remote ViewLog Service functions are enabled to allow remote access of GV-Edge
Recording Manager.
1. Execute the GV-Edge Recording Manager program.
2. Upon first startup, GV-Edge Recording Manager automatically searches for the GV-IP
Devices and the servers installed with GeoVision software that are under the same LAN.
3. When the search is finished, you are prompted to select hosts. Click OK to proceed.
4. Select a desired host by checking the box
. This dialog box appears.
5. Type the ID and password of the device and click OK.
To Next Page
Loading...
Need help?
General
